|
The iQpac
shows you battery capacity in mAh on
the LCD so you know how your battery will perform.
This test scapacity
against specifications. Then you can use your battery with confidence -
or replace it. This test is +/- 3% accuarte.
Know
Your Battery Capacity Faster -
with "Quick Analyze". This mode tests your battery while
charging. When you test during charge you estimate battery capacity in a
shorter time. This test is +/-10% accuarte.
Rejuvenate "Bad" Batteries
-
with the "Condition" mode. Restores NiCd and NiMH capacity in many
cases by recycling the battery through consecutive charge/discharge cycles,
removing crystal growth.
You get more use from many batteries that might otherwise be rejected.
Select from three charge
rates -
low (500mA), standard (1000mA) or high (1500mA) to test and
service all batteries capacities in minimal time.
Select Constant Current
Charge -
to test batteries for warranty
returns.
Select Negative Pulse
Charge -
to condition your NiCD battery during the charge. This is preferred by
some when using the iQpac as a charger. This is reputed to prevent memory and meet the highest
battery life claims.
Select Charge Volts for
Lithium Ion Model -
to match Lithium ion battery cut off at different voltage levels for
safety. (iQpac lithium ion model)
Lock Program Settings for Tamper-Proof
Operation -
a free Windows program locks charge type, rate, Li-ion charge voltage
and safety timer so you can prevent tampering in the field. (iQpac-to-PC
cable - $25)
Alll Saved in Flash Memory -
in case you forget to check
the LCD before removing your battery. The flash memory will also
remember the last program setting you used so you can start your next test faster.
|
